ANT-32000A HD Server / Decoder

Additional images

ANT-32000A HD Server / Decoder

Manufacturer Antrica
Part Number ANT-32000A

Availability: In stock.

Ex. VAT: £912.00 (RRP:£976.00) Inc. VAT: £1,094.40
Reviews Be the first to review this product
Add Items to Basket
Add to
Email Email to a friend

Short Description
ANT-32000 Full HD 1080P H.264 Video encoder/decoder with HDMI & CVBS I/O plus 2 way AAC audio. Supports YCbCr Video or WSXGA PC graphics via DVI + USB local record!

The ANT-32000 is a High Definition H.264 video and audio CODEC that can be used in several ways. Offering Full HD video and audio encode plus decode and full duplex mode, this is an industry first!

Firstly it can be used as al High Definition (HD) IP video server where video and audio sources are connected to it and the unit is connected to a network. Any PC that can reach it over the network can view the HD Video, listen to the audio and access all of its control features either using the supplied CMS (Central Management Software) or via a browser.

Secondly two units can be set up as an encoder / decoder pair. The signals (HDMI video, audio & control) arriving at the encoder will be decoded by the decoder. This is ideal for transmitting high quality video between 2 points in a building which has already had a network installed or between remote locations which are connected to the internet. Each unit can act as both an encoder and decoder allowing a 2 way video / audio link

Also the unit can be used as a decoder paired with any of the H.264 static cameras or the range of H.264 speed dome cameras sold by Antrica.

Finally the output of a PC at up to WSXGA resolution at 60Hz can be connected using a DVI to HDMI cable . The PC images can then viewed anywhere on a network. This feature is useful in Hospital applications for sending the output of MRI or CT scanners to remote locations. Video wall applications and others where third parties need to view the DVI output from a PC .

When used as an encoder or server the unit features a USB port allowing the attachement of a USB flash drive for local recording. The ANT32000 can record locally on loss of network, detected movement or on a local signal. Video can be pre-recorded before the event and can be retrieved remotely via a browser.

Key Features:

  • HDMI input and Output ports
  • High quality1920 x 1080 low bit rate H.264 video codec
  • HD and SD video supported
  • Video over IP via 10/100 Ethernet or WLAN
  • Static or dynamic IP -DHCP, PPPoE
  • One to One or one to many transmission Multicasting
  • Serial port, USB port, sensor/alarm I/O
  • Encode, decode or duplex mode
  • Standalone end to end video over IP
  • Video server to NVR or PC mode
  • Motion detection
  • 32kbps ~ 4Mbps
  • Automatic adaptive rate control for network bandwidth

Key Benefits:

  • Highest quality video at lowest data rates using H264 gives clearer images at low bit rates
  • End to end option allows for simple camera and monitor systems without need for a PC/ NVR
  • Video server allows user greater choice of wide range of analogue cameras
  • Local USB recording to flash/ hard disk guarantees images are stored in case of network failure
  • Local USB hard disk can be accessed over network
  • Duplex mode allows for 2 way video systems
  • Simple configuration over IP reduces installation time on site and allows for reconfiguration realtime
  • One ANT-32000 can be used in any IP network application for encode decode or 2 way transmission
Section Specification Description
System Operation System Embedded Linux -
Main Memory 128Mbyte DDR2 -
Flash 128Mbyte NAND FLASH -
Video Algorithm H.264/JPEG Encoding/Decoding H.264/AVC MP/L4
Input 1 x HDMI type A, HDMI RX -
1 x BNC, Composite or HD SDI HD SDI : option
Output 1 x HDMI type A, HDMI TX -
1 x BNC, Composite or HD SDI HD SDI : option
Resolution 1920x1080/30p ~ CIF/30fps 18 resolution steps
Bitrate 32kbps ~ 10 Mbps
Audio Algorithm G.711 -
Input 1 x 3.5mm JACK, LINE IN Single Mono
Output 1 x 3.5mm JACK, LINE OUT Single Mono
Sample Rate 8 kHz -
Bitrate 64kbps -
Alarm/Sensor Sensor Input 2 x Input (3 x Terminals) Default NO, 2 x Sensor In,  1 x GND
Alarm Output 2 x Output (4 x Terminals) Default NO, 2 x NO, 2 x COM
Network RS232 1 x Port (3 x Terminals)
RS422/485 1 x Port (4 x Terminals) Camera PTZ Control
LAN 1 x RJ45, 10/100M Ethernet -
Storage External Backup 1 x USB 2.0 Interface -
Security Yes -
Event Motion detection Yes -
Sensor Yes
Pre/post alarm Yes -
Camera control PTZ Various Protocol supported -
Preset Supported for specific camera -
Notify Alarm / E-mail -
Network TCP/IP, Multicast, HTTP, SMTP, FTP, DHCP, DNS, Dynamic DNS, RTP, RTSP -


Korean/English -
Power Input 2.5ΦPower Jack, 12V/0.5A
External Power Adaptor Output :12V/1.5A, Input : AC100V~220V -
PoE 802.3af Compatible -
Certification Domestic : MIC, Overseas: RoHS, CE, FCC
General 4 x System Status LED POWER/STATUS/LINK/TRX
2 x PHY Status LED PHY LINK/100M
1 x Default Setting Button -

  • Value added - 35 years of excellence
  1. Advice - Our qualified and experienced sales team provide advice based on their many years of experience within the video industry.
  2. Free Support - Our trained support experts provide you with 12 months free telephone support on your purchased product. Our support line is a standard local number, not a premium rate call.
  3. Quick Dispatch - 95% of online orders are dispatched within one working day. All orders are dispatched by insured next-working-day delivery services.
  4. Returns Service - Unlike many resellers, OneVideo will deal with returns on your behalf should your product develop a fault.
  5. Customer Services - Our prompt and courteous customer support staff are on hand to help with any queries.
Compare Products

You have no items to compare.